E-Curbs seal penetrations by using a plastic mold and a pour-in-place polymer seal. E-Curbs are designed for use on granulated modified bitumen, asphalt and coal tar B.U.R. (built up roofing), and are specified for PVC, PIB, and TPO single-ply roofing membranes. The service temperature range for the E-Curbs is -40 °F to 200 °F, but should not be applied at temperatures below 32 °F. This rectangular E-Curb was specifically designed to work with SnapNrack one-hole standoff kits and the SnapNrack HD standoff kits. E-Curbs also make good conduit penetration seals. Round E-Curbs are also available, if needed, but must be special ordered and purchased in lot sized quantities.
The M-1 Black Structural Adhesive can be used under standoffs for water protection on roof penetrations, and is compatible with most roof materials.
|SKU:||ChemLink Sealants and Adhesive|
Chem Link E-Curbs
E-Curb, 4.5″ x 3.5″ rectangle, Grey – three – E-Curbs, 1.5 gal pouches of one-part
pourable sealer, two 10.1 oz cartridge of M-1 131-01357
M-1 Black Structrual Adhesive and Sealant, 10.1 oz. Plastic Cartridge 178-06009